Flashforge Dreamer (NX) - Replacing the Heat Bed and Wiring - Part 2

The cable connecting to the heated print bed in my Flashforge Dreamer NX shorted out and the bed stopped heating.

This 2-part video series covers replacing the heated print bed and wiring.

Eventually I got a replacement heater printed circuit board and wiring from Flashforge for no cost under warranty (thanks Flashforge!), but in the meantime I bought a new one from Flashforge USA so I could get back to printing.

Part 1 covers:
1) Removing the bad print bed
2) Removing part of the wiring

Part 2 covers:
1) Removing the rest of the wiring
2) Routing the replacement wiring
3) Installing the new print bed and wiring it up
4) Applying Kapton tape to the exposed leads of the print bed to avoid metal tools (like spatulas) hitting them in the future.

Link to replacement heated print bed:
https://flashforge-usa.com/collections/parts-accessories/products/heating-plate-creator-pro-dreamer-inventor

Link to replacement heated bed wiring harness:
https://flashforge-usa.com/collections/parts-accessories/products/heat-build-plate-line

Link to Kapton tape:
https://smile.amazon.com/gp/product/B00N1RHE2Q/

These are the spatulas I used to help remove the pieces from the print bed:
https://smile.amazon.com/gp/product/B075SLTY8B/

These are the tweezers I used to help remove dripping filament from the print head:
https://smile.amazon.com/gp/product/B0845SKD7Z/

This is the wire brass brush I use to clean the nozzle tip:
https://smile.amazon.com/gp/product/B01J2BS92S/

Flashforge Dreamer NX on Amazon:
https://smile.amazon.com/gp/product/B07DPBRCYZ/

-------------------
Link to my Etsy Store:
https://www.etsy.com/shop/BetaCygniDesigns

---------------------
End Screen Video Acknowledgement: Cosmic Reef Video produced by NASA and the Space Telescope Science Institute (STScI).
https://hubblesite.org/contents/media/videos/2020/16/1277-Video