A 3D Printed Christmas Tree, Merry Christmas #Shorts

2 years ago
64

This is a 3D Printed Christmas Tree, and ornaments, that I made with my Ender 3 V2 and some standard PLA filament.
The tree was scaled up to 200mm and was printed with a 0.4 mm nozzle, 15% infill, 0.28 layers height, at 30 mms print speed, and no cooling or supports.
The ornaments scaled down to ~42% and (by accident) were printed at the same settings and came out fine. BUT, they needed a brim as some of them had small bases that would cause the print to fail. Although if I was to make them again I would print at a lower layer height and with cooling turned on.

All files can be found on Thingiverse:
Tree:
https://www.thingiverse.com/thing:1216450
Ornaments:
https://www.thingiverse.com/thing:5150554
Tree Topper:
https://www.thingiverse.com/thing:213356

Thank you for checking out my video. Hopefully you enjoyed it. If you have any comments, criticisms, or requests feel free to leave them in the comment section below.
Also, I livestream on multiple platforms everyday.
For a list of platforms I stream or produce videos on, visit:
https://www.calimeatwagon.com/watch/
If you would like to contact me, visit:
https://www.calimeatwagon.com/contact/
And, if you would like to help support the channel, check out my store at:
https://www.calimeatwagon.com/shop/

My Setup
Xbox Series X + HyperX Headset + CAD U37 Mic + AVerMedia LGP Lite + Shitty PC + OBS Studio + Cali Smoke

Here is a list of the games I own. If you would like to see content on them, let me know.

Grand Theft Auto V Online - Red Dead Redemption 1 & 2 - Kingdom Come Deliverance - Cities: Skylines - Deep Rock Galactic - Dying Light - Elite: Dangerous - World of Warships - Dirt Rally 2.0 - Wreckfest - The Long Dark - We Happy Few - Minecraft - Stardew Valley - Space Engineers - Stranded Deep - Green Hell - Cuphead - Far Cry - Enlisted - Microsoft Flight Sim

Loading comments...