Spot Micro Part 2

Robot Dog, Part 2.
In this video we will continue building a companion for Fred, Spot Micro.
In the first part we built both the front legs.
This time we build the back two legs.

This dog looks similar to the Boston Dynamic four legged robot named spot, only smaller, hence the name Spot Micro.
This version was created by KDY0523.

Already there have been other creators out there modifying the design to change or add features, so you know I will be looking at those as well.
In the original design, an ArduinoMega 2560 was used to run Spotmicro, however there are mods to allow the use of a Raspberry Pi, so this looks like the way I will be going :-)

This robot uses standard sized servos with most of the body being 3D Printed.
Each leg has 3 servos, for a total of 12 servos.
In this video I used:
http://www.thingiverse.com/thing:3445283 Spotmicro - robot dog by KDY0523
R_arm_cover.stl
R_arm_joint_mg.stl
R_arm_mg.stl
R_wrist_mg.stl
L_arm_cover.stl
L_arm_joint_mg.stl
L_arm_mg.stl
L_wrist_mg.stl
2 x JX Servo PDI-6221MG-180 servo.
4 x Tower Pro MG996R servos. (Not impressed with these, Might have to get more of the PDI-6221MG servos to replace these)
4 x F625zz Flanged Ball Bearing. (One in the wrist and one in the shoulder)
2 x M3 20mm long (Used to hold the Arm Cover onto the arm)
4 x M4 25mm long (Used to hold the bottom of the servo in place in the wrist)
20 x M4 20mm long (All other servo mounts)
16 x M4 Hex Nuts (Used on the shoulder and wrist servos)
8 x M4 Square Nuts (Used on the arm servo, imbedded in the arm)

Please consider joining my VIP's GoLucky and Louwrens Burger and my other Patreons Lmorales45 and Ratchet in supporting the channel on Patreon.
https://www.patreon.com/Cyber_One

Maybe drop into the discord server for a chat :-)
https://discord.gg/WzrBUTkthQ

See you in the next video :-).