[E9] Hawk 250 Chain rubbing on tire, grind noise at times, chain guide alignment. enduro dual-sport

The chain on my hawk was rubbing on the knobbies on the tire. upon further inspection I found the chain guide to be so far off its was useless and probably the problem. I'll have to drive it a few times to be sure but the small test drive I took it did not hit. the chain also used to make a grinding noise once in a while. I think it was the guide pushing it off the sprocket... I also found that with 500 miles my chain was shot. It's a non O-ring chain but I would expect it to last a little longer. Ordered an O-ring chain!

Informational Hawk Videos:
-Original assembly of the Hawk is here: (https://youtu.be/N4D1r23bGGk)
-100 mile review: (https://youtu.be/4wGeex-quZk)
-Re-jetted to a 110 Mikuni Main jet and shimmed up the needle jet: https://youtu.be/34yYWSolKc0
-RK O-ring chain 428so 130 links: (https://youtu.be/wbdgIb8kk5Q)
-17 tooth front sprocket: (https://youtu.be/QMxGwdBHbvA)
-Modified air box: (https://youtu.be/Q8AJg6Ec7Jc)
-Re-aligned chain guide, Tire/ chain rub: (https://youtu.be/jnosM4HOmgo)
-Adjusted valves: (https://youtu.be/RTpAcOuUf7w)
-Turn signal beeper cut, Under seat storage: (https://youtu.be/7f3lCERqhxc)
-Buritto tube install: https://youtu.be/m1RZf6wKEXo
- Oil change: https://youtu.be/k9o0ISG7eJg

WHERE TO BUY PARTS LIST:
Due to changing products, links, etc, If you want the product links, please go to www.motocheez.com and click the bike your looking for parts (upper right), this simplifies the links for all the parts I use and install on ALL my videos.

Thanks you for watching, PLEASE subscribe!
▽ Follow MotoCheez
Instagram: https://www.instagram.com/motocheez
Facebook: https://www.facebook.com/MotoCheez
Web: http://www.MotoCheez.com
Music clips: