How to Change Fix a Flat Tire

In this video we show you how to take off and put on a tire. Be safe and aware at all times.

APPLY WHEEL WEDGES

Wheel wedges go in front of or behind the tires to further ensure the vehicle doesn’t roll while you fix the flat tire. If you’re changing a rear tire, place these in front of the front tires. If your flat tire is at the front, put the wheel wedges behind the rear tires.
Bricks or large stones will work just as well as “real” wheel wedges. Just be sure they’re large enough to stop the car from rolling.

REMOVE THE HUBCAP OR WHEEL COVER

If your vehicle has a hubcap covering the lug nuts, it’s easier to remove the hubcap before lifting the vehicle with the jack. If your lug nuts are exposed, you can skip ahead
Use the flat end of your lug wrench to remove the hubcap. This will work for most vehicles, but some hubcaps need a different tool to come off. Consult your owner’s manual for proper hubcap or wheel cover removal procedures.

LOOSEN THE LUG NUTS

Using the lug wrench or impact driver, turn the lug nuts counterclockwise until you break their resistance. You may have to use force, and that’s ok. Use your foot or all of your body weight if necessary.
Loosen the lug nuts about ¼ to ½ of a turn, but don’t remove them completely yet. Save that for when it’s time to remove your tire/wheel from the vehicle.

PLACE THE JACK UNDER THE VEHICLE

The right place for the jack is usually beneath the vehicle frame alongside the tire that’s flat. Many vehicle frames have molded plastic on the bottom with a cleared area of exposed metal specifically for the jack. To safely lift and avoid damage to the vehicle, follow the instructions for jack placement in your vehicle owner’s manual.

RAISE THE VEHICLE WITH THE JACK

To prevent the jack from settling under the weight of your vehicle and coming off balance, place a small cut of 2x6” wood beneath it before attempting to raise your vehicle. This tactic is especially helpful on asphalt.
With the jack properly positioned, raise the vehicle until the flat tire is about six inches above the ground.
Never put any part of your body under the vehicle during or after raising the vehicle with the jack.

UNSCREW THE LUG NUTS

Now it’s time to remove the lug nuts all the way. Since you've already loosened them, you should be able to unscrew them mostly by hand.

REMOVE THE FLAT TIRE

Gripping the tire by the treads, pull it gently toward you until it’s completely free from the hub behind it. Set it on its side so that it doesn’t roll away.

MOUNT THE NEW TIRE ON THE LUG BOLTS

Now place the spare on the hub by lining up the rim with the lug bolts. Push gently until the lug bolts show through the rim.

TIGHTEN THE LUG NUTS BY HAND

Put the lug nuts back on the lug bolts and tighten them all the way by hand. Once they are all on, check each one again, tightening as much as possible. You will tighten them with the wrench after lowering the vehicle to the ground.

LOWER THE VEHICLE AND TIGHTEN THE LUG NUTS AGAIN

Use the jack to lower the vehicle so that the new tire is resting on the ground but the full weight of the vehicle isn’t fully on the tire. At this point, you should tighten the lug nuts with the wrench, turning clockwise, as much as you can. Push down on the lug wrench with the full weight of your body.

LOWER THE VEHICLE COMPLETELY

Bring the vehicle all the way to the ground and remove the jack. Give the lug nuts another pull with the wrench to ensure they’re as tight as possible.

REPLACE THE HUBCAP

If the hubcap you took from the old tire will fit your spare, put it in place the same way you removed it initially. If it doesn’t fit, stow it away with the tire when you stow your equipment.

CHECK THE PRESSURE IN THE SPARE TIRE

You should check the tire pressure of the new tire to make sure that it is safe to drive on. If the tire needs pressure, drive (slowly) to a service station immediately.

You can hit me up on my website 👇
https://krome606.wixsite.com/website

You can follow me on Instagram @Vendinomicsllc

If you want free money click the link below👇
https://join.robinhood.com/kevinr2387

https://act.webull.com/i/sFLv4fsfABKa/q35/wb_deposit_us_01

☝️ With those two apps I have learned how to invest in stocks and used the money I made as a start up for a Vending machine business. Use my Link and we will both get a free stock on Robinhood or on Webull we will get 2 free stocks!