FT8 MATLAB GUI APP for CQ call using HackRF One and GRC

3 years ago
83
SoftwareDefinedRadio​​ RPi4​​ FT8​​ SDR​​ SDRsharp​​ HAMRadio​​ AmateurRadio​​ RTLSDR​​ GNURadioCompanion

As proof of concept, here is a simple Matlab GUI app demonstration. Using earlier released code Matlab App designer was used to create a gui panel to enter callsigns and grid square locators and then transmit a cq call on FT8 using these. A flowgraph in GNU Radio Companion is used to take audio produced in Matlab and modulate an RF carrier producing an USB signal that is sent to the HackRF One. Transmissions at low power and with a short wire antenna are monitored using an rtl-sdr dongle via SDRSharp, VB Audiocable and WSJTX. Code available upon request.

Please support this channel. Thank you!

Sony Mic
https://ebay.us/o9QnZm

Labtec Speakers
https://ebay.us/eUWuv5
Yaesu transceiver
https://ebay.us/ok2tCf

Arduino
https://ebay.us/1BnA2S

https://ebay.us/tsueEH

https://ebay.us/SuGrey​​ #rpi4​​

https://ebay.us/uXXnSx​

#LimeSDRMini​

ADALM Pluto
https://ebay.us/2joEBG​

Xiegu G1M
https://ebay.us/poANqm​

Red Pitaya
https://ebay.us/H8s6FU​

KN-990 HF Transceiver
https://ebay.us/WDklKs

KN-990 HF Transceiver
https://ebay.us/WDklKs​​

Loading comments...