Wall Desk Build Part one

Hello everyone, this is Part 1 of 2 of my wall desk build. I originally had this idea for an area under a bulkhead in my basement. My wife found a desk similar to what I wanted on Pottery barn. However, its price was far outside what we could afford. This is my take on the Logan Desk.

This project will require a lot of straight cuts and breaking down plywood to the sizes you need.

You will need 6 sheets of 3/4 Poplar Plywood
2 sheets of Birch for desk top
2.5 sheets of 1/2 inches sanded plywood.
(12) 1x2x8 (Pine, Poplar, Maple, Red oak.)
(2)1x6x8 (Pine, Poplar, Maple, Red Oak.)
(1)sheet of MDF
(7) 1x3x8 maple

Kreg Jig Tools:
Pocket hole jig
Shelf Jig
European hinge jig
Kreg Jig fine thread screws 1” 1/4
Wood Glue (I prefer Titebond original)
Kreg Jig pocket screws

1 quart Polyshades Ebony
1 quart Polyurethane gloss
1 gallon White paint
paint Brushes for oil and latex paints

(120, 180, 220, 400)grit sand paper
Hardware of your Choosing
8 European style hinges for inset door
4 sets of drawers slides at 20" dept

Hand planer

Orbital sander

(Preference)
Finish nailer
Brad Nailer
Stable gun
Pin nailer