Bobcat 610 Clutch inspection, Adjusting chain tension and loose shaft fix
3 years ago
558
Bobcat 610 Clutch inspection, Adjusting chain tension and loose shaft fix.
Plan was to replace clutch wear plates, but on inspection the existing plates
had very little wear and found one side had no removable chain link (without
drilling) so I left the original plates in place.
2. After finding one chain was very loose and tightening it the side cover did
not go back on. Turned out a shaft was loose and tightening the chain pulled
the shaft over so the cover would not fit. Inspected some more and found the
loose nut, tightened it. Re-tensioned the chains, adjusted the clutches and put
the cover back on.
Loading 1 comment...
-
0:15
Monkeypunch
3 years ago $0.07 earnedBobcat second
307 -
0:50
tmusha
3 years ago $0.01 earnedBobcat suprise
127 -
0:15
Monkeypunch
4 years ago $0.01 earnedBobcat tva
87 -
0:38
Bizal008
4 years ago $0.02 earnedBig Bear Bobcat
112 -
3:32
Buckaroosid
4 years agoBobcat fire
41 -
0:15
Monkeypunch
3 years ago $0.01 earnedBobcat TVA 10 16 2020
71 -
0:55
ViralHog
4 years ago $0.06 earnedBobcat Strolls Through Backyard
265 -
3:00
WSYM
4 years agoBobcat of Lansing - 9/21/20
12 -
2:57
WSYM
4 years agoBobcat of Lansing - 8/4/20
6 -
3:00
WSYM
3 years agoBobcat of Lansing - 10/12/20
10