Building the Shop - Part 31 - In Floor Heating Pipes and Elbows

In this episode, "Building the Shop - Part 31 - In Floor Heating Pipes and Elbows" we are laying on Rehau 1/2" Pex Pipe and Elbow.
We built ourselves a Pex unwinder using #theultimatequadtrailer and a couple pipes.
This took us about one and a half days as we started laying the Pex Pipe right after we finished the last episode.
We got two runs done the first day and six ran the second day.
I have to say that the zip ties we bought from Amazon worked great but were very hard on my fingers.
Until the next one, keep Living the Northern Life!

You can help support the channel if you Subscribe and hit the Bell notification for All updates so that you are notified when I post a new video.
We have a new Patreon account as well if you would be willing to support us this way as well.
https://www.patreon.com/livingthenorthernlife
You can also help support the channel by clicking on the links to any of the items below.
Even if you choose not to purchase any of these items we would receive a commission if you purchase any item from Amazon within 24 hours of clicking on any link below.

Amazon Affiliate Link
Canada: https://amzn.to/31AufV8
USA: https://amzn.to/34HXNT2

9 inch Chainsaw Tooth Brush Blade
Canada: https://amzn.to/2CQJPm7
USA: https://amzn.to/2ECFlQB

0:00 Intro
0:10 Plans
0:57 Writing Measurements on the Form Wall
1:43 First Run of Pex for In Floor Heating
5:54 Don't Undo All the Strings on the Pex Roll
8:32 All Pex is Laid and Next is to Zip Tie
9:40 Zip Tying Every 2 feet Until My Finders Bled
11:13 Done with #theultimatequadtrailer for Now
11:24 Installing Elbows onto the Pex Pipe Exiting the Concrete Floor
13:27 More Zip Tying
13:58 The Base is Completely Done! Closing Remarks
16:22 Outro