Building the Shop - Part 21 - Cutting the First Amvic Silverboard for the Sloped Corners

In this episode, "Building the Shop - Part 21 - Cutting the First Amvic Silverboard for the Sloped Corners", we are testing our first sloped corner and cutting our Amvic Silverboard to see if we can get the slope and angles correct.
The slope itself will takve more than half a sheet but I was hoping that with the sharp angle that we could still get two useable pieces for the slope.
We ended up just cutting the 4'x8' sheet of Silverboard in half length ways because this way the bottom edge of the corner was exactly where it needs to be but we are missing the wedge closest to the footing.
Until the next one, keep Living the Northern Life!

You can help support the channel if you Subscribe and hit the Bell notification for All updates so that you are notified when I post a new video.
We have a new Patreon account as well if you would be willing to support us this way as well.
https://www.patreon.com/livingthenorthernlife
You can also help support the channel by clicking on the links to any of the items below.
Even if you choose not to purchase any of these items we would receive a commission if you purchase any item from Amazon within 24 hours of clicking on any link below.

Amazon Affiliate Link
Canada: https://amzn.to/31AufV8
USA: https://amzn.to/34HXNT2

9 inch Chainsaw Tooth Brush Blade
Canada: https://amzn.to/2CQJPm7
USA: https://amzn.to/2ECFlQB

0:00 Intro
0:10 Plans
1:48 Setting up to Cut the Silverboard
7:03 Test fitting the cut Silverboard on the North West Slope Corner
7:34 The Angle Cut in Detail
9:29 Cutting More Pieces and Test Fitting
12:33 Closing Remarks
14:02 Outro