Simple DIY Router Edge Guide

Router edge guides can either be expensive or too small to be effective, so I wanted to build my own out of plywood. This is a super simple design so it should be easy for anyone to DIY this. I made this to help add dados to plywood if I don't want to use a dado stack.

🖥️ Website: https://www.fangerwoodworking.com/

🔨 Tool links (Amazon links are affiliate links which I may earn a commission from if items are purchased, at no additional cost to you, however, they are not sponsored products):
Safety Gear
- Micro jig narrow rip push block: https://amzn.to/3Nl97ZF
- Micro jig paddle push block: https://amzn.to/43Ic9ON
- Milescraft push stick: https://amzn.to/3NDlDoW
- ISOTunes ear protection: https://amzn.to/44aYpMd
- 3M work tunes https://amzn.to/4acMdht
Measuring
- FastCap measuring tape: https://amzn.to/3qYM9Ao
- Setup blocks: https://amzn.to/3NFobCZ
Sanding
- Bosch sander: https://amzn.to/3qVilEE
Saws
- Bosch job site table saw: https://amzn.to/46t1nhl
- Bosch track saw: https://amzn.to/43RNS8T
Joining
- wen biscuit joiner: https://amzn.to/3CGt8Fm
Drilling
- Forstner Bit Set: https://amzn.to/3NGbMi8
Other
- auto vacuum switch: https://amzn.to/42SayEE
- 2P10 super glue and activator: https://amzn.to/3Pot7gU
- Bosch dust extractor: https://amzn.to/3PmF8Dk
- WEN air cleaner: https://amzn.to/3JoWj3B
- HDPE miter bars: https://amzn.to/3LvXDma
- Toggle clamps: https://amzn.to/3LteTbN