Chapter 21 1970 TransAm Clone - New trunk lid

Here is a summary of this week's progress:
1) Weld in trunk hinges and weld up trunk lip edge. The torsion rods have not been installed.
2) Fit passenger side rear tail pan to quarter panel. Fabricate new filler piece for tail light pan to quarter panel.
3) Welded up driver rear tail pan to quarter panel.
4) Gap trunk lid and modify to fit trunk filler panel
I give a view of both mini-tubs from inside the passenger compartment. Here is a bit of trivia about the new trunk lid. I was able to find one that had the holes for rear spoiler center section already drilled out