Resonant Current Magnifier

2kw output simulation, 80 watts in.

- This process does not use any batteries.
Storage is the circuit capacitors for DC and coils for magnetic. Source of storage must be per-charged prior to start up. Such as how one one would charge a regular battery and operate from it.
This process uses super capacitors to emulate the batteries. We split the bank in two. The run bank and the charge.

- This process offers over-unity without breaking any laws of physics.
This is over-unity with the help of resonance. The effect of total output wattage is proportional to the requirement load. It will not just generate total power into a load that is not "asking" for it. According to the simulation.

Another way to look at it this. This process does not over load on itself with excess current. The process is perfectly balanced with the help of a dual tuned resonating circuit along with the load current requirement. By the process of natural equalization between two different capacitor voltages combining two oscillating L/C circuits.

With this process, We are having always one of the two capacitors that are sharing common ground, They are both charged at much greater voltage difference potential between them thanks to the oscillations of the this dual L/C circuit and the efficient transformers transformer free V-I change. Those 2 capacitors are Joined (shorted) by a load, at each opposite ends, (see fig) Causing a very vast voltage imbalance between the two capacitors. This generates an imbalance of voltage between the load 2 connecting opposite points. As a result. The the universe tries to maintain natural equalization (quantum) between two points in voltages, With all it knows,. This process moves power to the running load, in between the two capacitor voltage points. At This stage. This is now load resistance generating current according to ohms law. power resides in that load.

How ever power does not just get made. You can not make power. We can Just transfer it from one type of system to another. We can only manipulate. it. We as of so far only know of the ohms law. So we can make an estimate based on what we know from ohms law assuming it is of similar in the world of quantum physics until someone can prove otherwise. This running process "manipulates" the equivalent of several k amps from the quantum in order to maintain and restore this perfect universal equalization balance of voltage between two points.

- Each Transformer stage can generate up to 2.1 kw.
with calculated values, An input square wave of 110 volts DC pulsed at 50-60 hertz with a duty cycle of 50 percent. 80 watts is needed to drive the process to a state of resonance. (see fig) Input low power drive, varying depending on where the oscillation cycle is at.

-This process uses L/C resonance.
Taking advantage of super conductivity properties of a L/C circuit at the resonance 50-60 hertz point. The L/C stage becoming 0 ohms at this frequency. allows for a direct connection to be made at the DC point between the two capacitors connected at each end of the primary and secondary winding, joining together at ground point. The most profound result of this is the sudden effect of a low current being transferred to the high voltage side by a virtual direct DC path caused by the resonance effect at that very sharp specific tuned l/c frequency of 50-60 hertz. Tesla was very afraid of this effect of the human body accidentally suddenly being conducted as the bridge between the high voltage secondary low current side and the low voltage high current side while oscillating gives the human body a lethal shock of several kilo-volt at also high current.
80 watts 110 volts pulsed DC(12 volt DC-AC inverter) is relatively low power in the primary side. When that 80 watts gets transferred over to the high voltage side and now we are reading simultaneously the same current reading on both transformer ends. the high voltage side can get a whole of extra work done at 1kv 80 watts. We then send this to a spark gap assembly that pulses this high voltage and very same current as the 110 side, but considered much stronger in 1kv oscillations! The spark gap feeds a regular AC high voltage to low voltage transformer operating in regular mode so it can steps down 1kv 80 watts equivalent power to 110 AC 50-60 hertz 2.1 kw power.

- This process also utilizes Tesla's well known method of shorting a tuned L/C circuit.
the spark gap at just the right interval pulse frequency. When current and voltage are at its peek. At high voltages this "shorting" effect helps us extract even more watts out of the surrounding atmosphere (radiant energy, Such as nearby RF and magnetic fields but not limited to just such. All radiant energy, including, local scalar and gravity waves) for a moment, pulling it in along with the oscillation pulse cycle.

- This process takes advantage of the negative resistance properties of the spark gap by operating in Region B. As a Negative Resistance.