Evaporative Emissions Purge Valve Replacement 07 Ford Edge 3.5L

In this video I show how to replace an evaporative emissions purge valve on an 07 Ford Edge 3.5L. The process I use is very simple. I first disconnect the electrical connector. Then I disconnect both of the lines going to it. I then remove the valve from the mounting bracket. Installation is the reverse procedure.

As mentioned in the video, your new valve may come with the mounting bracket. If you wish to replace the valve with the mounting bracket all you'll need to do is remove the mounting nuts shown in the video that hold the bracket to the fire wall. Remove the valve and bracket together as an assembly.

Also, as mentioned in the video, the valve can be changed without taking the air duct off. It does help to take the air duct off, however. If you take the air duct off be sure that all the hoses are reconnected when going back together and be sure all hose clamps are tight.

DISCLAIMER
Barbour's Auto Help is not responsible for any damage or personal injury incurred in the process of performing any auto repairs done by you the viewer. Automotive repair is extremely dangerous. Repair your vehicle at your own risk. It is the viewers responsibility to verify all information and procedures as outlined in YOUR REPAIR MANUAL AND OWNERS MANUAL FOR YOUR VEHICLE. Owning and using a repair manual suited for your vehicle is essential for correctly and safely performing ANY repair to your vehicle. Always wear safety glasses and heed all instructions for use applicable to any piece of equipment you may use. Due to circumstances out of the control of Barbours Auto Help, Barbours Auto Help makes no guarantee that by the use of the information given in this video a quality repair will be made. Barbour'sAutoHelp makes no guarantee that the information provided is totally complete, syncronized and accurate. Verify everything using an appropriate repair manual.