Flashforge Dreamer (NX) - FilaCube Black PLA Testing - Cold Garage - Part 1

This three-part series shows the testing of FilaCube Black PLA 1.75mm Filament using a Temperature Tower, a Bed and Layer Adhesion Test, and a low polygon black panther.

Part 1 covers the filament, temperature tower, and bed adhesion test.
Part 2 covers printing the low polygon black panther two different ways and compares how they each came out.
Part 3 covers gluing the panther printed in halves and comparing the final product.

Link to FilaCube Black PLA2 Filament 1.75mm on Amazon:
https://smile.amazon.com/gp/product/B0777NX5KZ/

Link to Temperature Tower Thingiverse Project:
https://www.thingiverse.com/thing:4356906

Link to Bed Adhesion and Layer Cracking Test
https://www.thingiverse.com/thing:4536632

Here's a link to Panther - Low Poly on Thingiverse:
https://www.thingiverse.com/thing:4259549

These are the spatulas I used to help remove the pieces from the print bed:
https://smile.amazon.com/gp/product/B075SLTY8B/

These are the tweezers I used to help remove dripping filament from the print head:
https://smile.amazon.com/gp/product/B0845SKD7Z/

This is the wire brass brush I use to clean the nozzle tip:
https://smile.amazon.com/gp/product/B01J2BS92S/

Flashforge Dreamer NX on Amazon:
https://smile.amazon.com/gp/product/B07DPBRCYZ/

OpenSCAD website:
https://www.openscad.org/

I used Simplify3D slicer software for the test:
https://www.simplify3d.com/

-------------------
Link to my Etsy Store:
https://www.etsy.com/shop/BetaCygniDesigns

---------------------
Music:
"Blippy Trance" Kevin MacLeod (incompetech.com)
Licensed under Creative Commons: By Attribution 4.0 License
http://creativecommons.org/licenses/by/4.0/

---------------------
End Screen Video Acknowledgement: Cosmic Reef Video produced by NASA and the Space Telescope Science Institute (STScI).
https://hubblesite.org/contents/media/videos/2020/16/1277-Video