Kel-Tec PMR-30 Mag Speedloader - 30 round .22WMR mag loading - 1st method

- Made in the USA from PETG plastics (Coke bottle material, much stronger than PLA, and higher temperature resistance). SEE VIDEOS ABOVE. Free Shipping!!!

- Our "Syringe" style grip/loading makes loading Kel-Tec PMR-30 magazines easier and faster (See videos).

- I am the original designer of this "Syringe" style loader.

- To provide the best and strongest quality product, each speedloader takes around 5.5 hours to make with PETG.

- Works with Kel-Tec PMR-30 double stack .22 WMR magazines only.

- Takes me an average 1 min 11 secs to PROPERLY load 30 JHP's into Kel-Tec 30 round .22 WMR mags. See videos above for 2 methods of loading.

- This SHOULD be the stock magazine speedloader that comes with your Kel-Tec PMR-30.

- Magazine is not included, only the loader for Kel-Tec PMR-30 double stack .22 WMR magazine is shipped.

Designer's Notes and Disclaimer: This loader EMULATES HAND-LOADING. The shorter plunger design was used since the taller plunger would eventually break over time due to the EXTREME staggering of the rounds when using the method of sliding the full round under the feed lips to load. This will happen to all designs using the tall plunger whether using Nylon, ABS, or whatever plastics with Nylon taking the longest time to break. Also, the taller plunger method of sliding the full round under the feed lips during my testing caused many misalignments. From tests conducted using just hand loading of 30 rounds, I was still getting dents in the shell casing for the last 10-12 rounds. This loader design tries to minimize these dents by ELONGATING the plunger from the front of the round to the back rim by spreading the downward force evenly.

Ebay:
https://www.ebay.com/itm/314292573476