Throttle Mirror Mod & I forgot to Check it!

#Paramotor Flight VLOG #11:

9/14/22 Moved bag to right side of my frame but not happy w the wiring, may need to add gromet to bag to run wire away from zipper. Tested flasher circuit and LEDS. adding to frame in future.

9/15/22 added audio cable to helmet gopro to record audio from sena.

Flight #11: Left around 6pm to go here at the local field and see if I have enough time for a quick test flight. We were able to set up quick but winds changed and I decided to launch opposite to wind. Wing was falling a bit behind on takeoff but I was able to correct and takeoff was successful. I made a few turns to gauge wind direction and then as it was getting dark I decided to call it a night and come back down for a landing. I forgot to test the mirror I 3D Printed a mount for. bag location was also swapped to my right side for now to see if it was easier to open in the air for me. when I have more time in the air I will go higher and try again. Wasn't able to finish the connectors for the LEDS so they are able to be disconnected from the frame, will add that and flasher later. I do enjoy having access to the battery box now that it has been moved. my gopro hero 3black was tested with lens that has wider field of view and it was able to see a bit better in low light. Landing was smooth but wing did fall with leading edge on ground.

#ppg #paramotors