How To Make A Box - Full Guide - XTool D1 Pro 20W Diode Laser Cutting Project

2 years ago
134

I'm going to be making a lot of these....

⭐xTool D1 20W Laser Kit - https://www.xtool.com/products/portable-diode-laserbox-d1-for-laser-engraving-laser-cutting-b?ref=RedBeardOps&utm_source=influencer&variant=43022796554479

⭐ xTool Air Assist - https://www.xtool.com/products/air-assist-set?ref=RedBeardOps&utm_source=influencer

MakerCase Plans - https://www.makercase.com/#/basicbox

🛠 Notable Items and Tools:
12x18 Wood - https://amzn.to/3Dt90If
Honeycomb Table (400x400mm) - https://amzn.to/3RmYaba
Amazon Link To XTOOL - https://amzn.to/3qsZbCG

#xtool #lasercuttingmachine #laserengraving

00:00 - Intro
00:24 - LightBurn Set-Up
08:11 - Into The Shop
14:06 - Box Assembly
**********************************************************
A Notice from Red Beard Ops LLC:
The information provided on this channel is for entertainment purposes only. Any action you as the viewer takes upon the information on this channel is strictly at your own risk, and Red Beard Ops LLC will not be liable for any losses, damages, or personal injuries in connection with the use of this content (including injuries, damages, or losses sustained while you were trying to emulate the actions and projects on this channel). Attempting to emulate any of the actions or projects put forth by this channel should not be done without training and even then, at your own risk.

Loading 1 comment...