Step By Step Guide On How To Clean Your Cotton Candy Machine

Treating your clean candy cotton machine right is one of the best tips to extend its lifespan and enhance its performance. In this case, cleaning is one of the essential steps. There are several other reasons why someone should clean his machine often.

Table of Contents
How To Clean Cotton Candy Machine
Requirements
Routine Cleaning Tips
Step 1: Turn On the Candy Machine for Around One Minute
Step 2: Turn the Machine Off and Unplug From Main Power Supply
Step 3: Soak Individual parts in a Hot Water
Step 4: Plug in the machine
Frequently Asked Questions
How To Clean Cotton Candy Machine
Treating your clean candy cotton machine right is one of the best tips to extend its lifespan and enhance its performance. In this case, cleaning is one of the essential steps. There are several other reasons why someone should clean his machine often.

The area around the base and motor are hard to reach when you dust the machine unless you thoroughly clean them. Below is a detailed guide on how to clean your cotton candy machine to reduce burnt sugar chances and prevent the motor from overheating.

Requirements
– Hand gloves

– Apron, hairnet, and mask

– Damp Cloth

– Toothbrush/nylon brush

– Fresh dry paper towel

– Hot water

– Oasis 133 solution

Routine Cleaning Tips
– Ensure the heat switches and motor are turned off

– Allow the spinning head unit, along with other components, to typically cool down to a safe-to-touch temperature.

– Get rid of the leather floaters and four retaining nuts of the spinning head machine.

– Remove the slinger plate via loosening the nylon acorn nuts located at the center.

– Disconnect the heater lead terminations via remove the two nuts

– The screen and top assembly with the heating element should also be cleaned using mild detergent and hot water

– At this point, the head base will be accessible to be able to remove all sugar residue manually using a damp cloth

Step 1: Turn On the Candy Machine for Around One Minute
Do this at high-temperature settings. Generally, this step will help break down and melt the hardened sugar around the central floss heat. Besides, the micro holes in the machine spin head might be challenging to clean when sugar has burned or hardened on them. Therefore, leaving your machine running for seconds to one minute will make it easier to clean off residual sugar.

Step 2: Turn the Machine Off and Unplug From Main Power Supply
Make sure you give the unit time to cool down before cleaning starts into a comfortable touch. Open the machine lid and remove all your candy. Detach the detachable parts. Remember to cover the opening using a towel now that the wires are left exposed to prevent outside contaminants. After, get rid of the extractor head via gripping both sides, followed by pulling it straight up.

Further, unlock the bowl by turning it clockwise and lifting it. Use warm water and a damp cloth to wipe the parts. Preferably dip the cotton tips in warm water, followed by cleaning inside the extractor heat thoroughly. Dry completely. Use Oasis 133 solution to clean the cover and pot and soak them for around 2 minutes.

Step 3: Soak Individual parts in a Hot Water
Some parts may be hardened by the sugar, and wiping cannot make them clean. In this case, soak them in hot water. A slight detergent may help as well but avoid using harsh abrasive cleaners as they can damage the surface. After a good soak for around 2 and 5 minutes, take a toothbrush or nylon brush to clean any left bits of sugar.

– Cleaning the burnt sugar

Soak in vinegar and utilize an abrasive pad to ideally scrub away. It is crucial to clean any burnt sugar as soon it starts forming. Apply a slight coat of grease or oil to the candy cotton machine moving arts if desired.

Step 4: Plug in the machine
Ensure all the parts are fully dry before you reassemble them. Plug in your machine to the power cord and turn it on. At this point, spinning augers will evenly mix up with candy mixture, producing stars or preferably other desired shapes inside the machine.

Put your cotton candy machine in a large enough plastic bag to typically prevent air exposure and dust. And store it at a dry, normal room temperature.

Takeaway

It would be helpful to clean the cotton candy machine right after every use to avoid allowing sugar and syrup to build- up inside the machine.

Frequently Asked Questions
– How frequently should you clean the cotton candy machine?

At least once a week and, if possible, after every use to prevent hardening sugar that becomes hard to clean when left uncleaned for days.

– What Temperature is a Cotton Candy Machine On to Avoid Hardened Sugar?

Adjust the temperature to 338 and 482 degrees F, warm up to 5 to 6 minutes, and your delicious cotton candies will be perfectly done.