What if It's A Long Valley to Cut Metal Roofing #Shorts

If this was a real long angle, okay? I would do that square piece again and then I would measure from that point to measure up to that mark. But in this case, it's short. So I may actually able to measure across the top and measure up for my length.

That's my mark for on the right-hand side from that point to that point. And then the over, since it's less than 37 inches wide, which is what these panels are.

🙏 Subscribe, 👍, it helps a lot!!
➤❓/ 💬: ask@straightarrowrepair.com
➤ Follow https://straightarrowrepair.com/pipf

➤➤I get a little for the channel-no charge for you if you use the links:
➤➤Shop Amazon https://amzn.to/3CxD1T4
➤➤Tool lists & recommended products🧰 https://straightarrowrepair.com/0lvf

➤➤Services We use
➤➤MORNINGFA·ME https://morningfa.me/invite/StraightArrowRepair
➤➤A2 Hosting http://www.a2hosting.com/refer/140244
➤➤Tubebuddy https://www.tubebuddy.com/StraightArrowRepair
➤➤Apsumo http://fbuy.me/v/philbridges
➤➤VidIQ: https://vidiq.com/straightarrowrepair

#metalroofing #metalvalleycuts #roofing Straight Arrow Repair,handyman,trailer home,house,mobile home,rogers arkansas,corrugated metal roof,corrugated metal roof installation,how to cut metal roofing,how to cut metal roofing to length,metal roof installation details,metal roof installation process,metal roof repair,metal roofing installation diy,metal roofing tips and tricks,new wiss snips,metal roofing installation,metal roofing valley installation,wiss snips,valley flashing