How to Measure For Roof Penetrations #Short

Okay, guys, there's another dilemma that you run into is having to cut the penetrations for the roof. In this case, it doesn't fallout anywhere on. It's going to go right over the top.

What I'm going to do again is to lap over, going to measure to show 4" to 14. Then measured from the top need 13, which I can actually write there, make a mark and 23. That's the area that I'm going to cut it and then I'll show you how I cut. One of the ways that I can cut.

🙏 Subscribe, 👍, it helps a lot!!
➤❓/ 💬: ask@straightarrowrepair.com
➤ Follow https://straightarrowrepair.com/pipf

➤➤I get a little for the channel-no charge for you if you use the links:
➤➤Shop Amazon https://amzn.to/3CxD1T4
➤➤Tool lists & recommended products🧰 https://straightarrowrepair.com/0lvf

➤➤Services We use
➤➤MORNINGFA·ME https://morningfa.me/invite/StraightArrowRepair
➤➤A2 Hosting http://www.a2hosting.com/refer/140244
➤➤Tubebuddy https://www.tubebuddy.com/StraightArrowRepair
➤➤Apsumo http://fbuy.me/v/philbridges
➤➤VidIQ: https://vidiq.com/straightarrowrepair

#MobileHomeRepair, #MobileHomeImprovement, #DIYHomeRepair, commercial metal roofing installation,diy metal roof,Metal roof,metal roof installation,metal roof installation over shingles,metal roof penetration,metal roof penetration installation,Metal roof penetrations,metal roof pipe boot,metal roofing 101,metal roofing installation,metal roofing tips and tricks,pipe boot,roof tar,roof tar for leaks,roof tar sealant,sealing roof with tar,standing seam metal roof,Straight Arrow Repair,vent pipe flashing