How to make a Motorcycle Fender (Part 3): Using a Shrinker / Stretcher

https://www.proshaper.com
Our Amazon Storefront:
https://www.amazon.com/shop/proshaper

How to make a Motorcycle Fender (Part 3): Using a Shrinker / Stretcher

Wray starts off by planishing the motorcycle fender where the edges were tipped. Then he makes a cardboard template using a motorcycle wheel we have in the shop, this is to ensure the correct curve is in place. This is when the Kick shrinker / stretcher comes in to play. Using a series of shrink and stretch dies Wray shrinks half way on the edge of the fender using the cardboard template as a guide. He then moves on to the Harbor Freight English Wheel to remove that peak where the duck tale is going. Finally another round of stretches and shrinks and this is where part 3 ends.

Email: Wray@Proshaper.com
Website: https://www.proshaper.com
Facebook: https://www.facebook.com/ProShaper/
Instagram: https://www.instagram.com/proshaper/
Twitter: https://twitter.com/ProshaperM
Linkedin: https://www.linkedin.com/company/proshaper