Duckin' the Fog, Episode 23, Sandblasting cabinet 220L. assembly required

4 years ago
19

Howdy YouTubers!
today we're unboxing and assembling the cheap chinese 220L sandblaster cabinet.
as is customary with any chinese made tool this unit too has issues. while i will spare you the agony of the guessin&b'goshin of the assembly process, here are some of the issues that will need to be addressed by a person purchasing one of these:
1) the screws are abysmally poor quality and largely of the wrong length. this unit should be assembled with 1/4 panhead or 6mm panhead screws. of course there are various locations the require different length of screws.

2) hole alignment: often it took a minimal amount of pushing and pulling to get the screws to go into the holes but there were a few positions that required quite a bit of force.

3) air supply: the connector is in a place that makes it vulnerable to damage during loading and unloading of the cabinet. relocation is a must. also an air dryer and pressure regulator are good addition that will help it work better.

4) internal illumination: the 10W LED light bar just doesn't light the cabinet up in daylight conditions to see well inside. definitely need to get something with more lux.

music:

"Monkeys Spinning Monkeys" Kevin MacLeod (incompetech.com)
Licensed under Creative Commons: By Attribution 4.0 License
http://creativecommons.org/licenses/by/4.0/

#sandblasting cabinet

Loading comments...