Datsun 510 Floorpan Welded & Rocker Removed (Ep# 45)

Front floorpan is in, & rocker panel is out! I started by using a hammer and dolly to line up the inner lip of the floor pan and welded them together, then I Use a spot weld remover to remove the remainder of the spot welds on the rocker panel and removed the rocker panel. Today was a great day!

Car: 1972 Datsun 510
Engine: L20B
Transmission: 280zx 5-Speed
Suspension: Rear Coil Overs
Minor Mods: Battery to Trunk, Electric Fans,

Equipment Used in the Videos:
Camera: GoPro Hero7 Black : https://amzn.to/2GrWDxa
Gopro Mic Adapter: https://amzn.to/2WziAkj
Gopro Case that holds the microphone adapter: https://amzn.to/2uBqoWH
Wireless Microphone: https://amzn.to/2JW0gjZ
Soldering and Hot Air Station: https://amzn.to/2YGqeLI
Spot Welder Bit: https://amzn.to/2UuINyT
Blaire Lubricant: https://amzn.to/2VTFfYy
SEM Copper Weld: https://amzn.to/2Dr8V8p
Voice Over: Power Director 17
Editing Software: Power Director 17
Music: By Andromeda: https://www.reverbnation.com/andromedamusicofficial

Build Thread Information:
RATSUN: http://community.ratsun.net/topic/72953-aarons-1972-datsun-510-4-door-glory/page-1
GRM: https://grassrootsmotorsports.com/forum/build-projects-and-project-cars/datsun-510-4-door-project-name-tbd/134878/page1/