C5 Corvette painting and part # 4 of the coupe to Z06 Conversion.

2 years ago
18

In part 4 of DIY Corvette Refinishing and coupe to Z06 while the rigid quarter panels are still attached to the vehicle I’m going to take advantage and prep as much of the exterior as possible because it’s easier to do mounted then on stands etc or sliding around on the floor.

I cover sand paper grits, sanding pads, and the use of glazing putty’s to repair minor blemishes, chips, scratches and so on.

As usual there are links below to the products that I am using. Pay special attention to the Dia of a sanding pad you order please.

#corvette
#c5corvette
#c5z06

Links to products that I am using in this video. Consider following the Amazon links as it does support the channel, all commissions earned from the channel go back in to the channel to bring you the viewer higher quality content.

LED Work Lamp.
https://amzn.to/3oJiSo6

Body Filler Spreaders.
https://amzn.to/3qxD1hN

USC Pronto Spot Putty.
https://amzn.to/2TgVoLu

180 Grit Sandpaper. Hook and Loop.
https://amzn.to/361Mpkk

320 Grit Sandpaper. Hook and Loop.
https://amzn.to/3qxDJM1

Hand Sanding pad. 5” Dia. (Use this one only if you order 5” Dia. sandpaper)
https://amzn.to/3h14h58

Hand Sanding pad. 6” Dia. (Use only with 6” Dia. sandpaper)
https://amzn.to/3x5s21B

Loading comments...